LiftCodex is in alpha — data and features are still being refined.
LiftCodex

Dips Strength Standards

For women · by bodyweight · in lb

Calculate your 1RM →
Average female Dips
71 lb
at 148 lb bodyweight · Intermediate level
Bodyweight ratio
0.48×
bodyweight at intermediate level

Dips are a compound bodyweight movement training the chest, triceps, and anterior deltoids. Standards are expressed as bodyweight reps. Once bodyweight dips become easy, adding weight via a dip belt produces rapid strength gains. Dips are among the most effective upper-body mass builders.

Beginner
Top 80% of lifters
Novice
Top 60% of lifters
Intermediate
Top 40% of lifters
Advanced
Top 20% of lifters
Elite
Top 5% of lifters

Find Your Level

Enter your stats and we'll highlight your row and level in the table below.

Don't know your 1RM? Calculate it →
Bodyweight (lb) Beginner
Top 80%
Novice
Top 60%
Intermediate
Top 40%
Advanced
Top 20%
Elite
Top 5%
110 26 lb 44 lb 62 lb 84 lb 108 lb
121 26 lb 44 lb 62 lb 84 lb 108 lb
132 26 lb 44 lb 62 lb 84 lb 108 lb
148 31 lb 49 lb 71 lb 95 lb 121 lb
165 35 lb 55 lb 77 lb 101 lb 126 lb
181 37 lb 62 lb 86 lb 112 lb 139 lb
198 37 lb 62 lb 86 lb 112 lb 139 lb
220 40 lb 66 lb 93 lb 121 lb 150 lb
242 44 lb 71 lb 99 lb 130 lb 161 lb
264 44 lb 71 lb 99 lb 130 lb 161 lb
286 44 lb 71 lb 99 lb 130 lb 161 lb
308 44 lb 71 lb 99 lb 130 lb 161 lb

Dips Strength Standards for Women

These dips strength standards cover female lifters across a range of bodyweights in LB. Each row shows five thresholds - Beginner, Novice, Intermediate, Advanced, and Elite - representing roughly the top 80%, 60%, 40%, 20%, and 5% of the lifting population at that bodyweight. Use the "Find My Level" tool above to enter your one rep max and see exactly where you stand.

Standards are based on aggregated data from large populations of raw, natural lifters. An intermediate dips is a realistic long-term goal for most people who train consistently - it typically requires 2–4 years of progressive training with structured programming. Advanced and Elite levels represent competitive performance and require deliberate, periodised training over many years.

Strength levels are always relative to bodyweight. A dips that is elite at 60 lb bodyweight is only intermediate at 100 lb - the absolute numbers scale with size. This is why every row in the table shows different thresholds rather than a single cutoff. If you are between bodyweight brackets, the standard for the nearest bracket is a reasonable guide.

Dips Technique Cues

Setup
  • - Grip parallel bars, body supported on straight arms
  • - Slight forward lean for chest emphasis; upright for triceps
  • - Cross feet behind you to reduce swinging
Cues
  • - Lower until elbows reach 90 degrees minimum, ideally upper arms parallel to floor
  • - Drive up by straightening the arms fully
  • - Control the descent - do not drop
Common Mistakes
  • - Not going deep enough - short range of motion limits muscle development
  • - Shrugging the shoulders up at the bottom position
  • - Excessive forward lean for tricep dips (shifts emphasis away from triceps)

Frequently Asked Questions

How much should a women dips?

For an average women weighing around 143 lb, an intermediate dips is approximately 71 lb. Standards vary significantly by bodyweight - use the "Find My Level" tool above with your own bodyweight to get a personalised figure.

What is a good Dips for a beginner?

A beginner standard represents a lift achievable after a few months of consistent training - roughly the top 80% of the lifting population. For most exercises, this is around 50–60% of bodyweight for upper body movements and 75–100% for lower body lifts. Check the Beginner column in the table above for the specific number at your bodyweight.

How are Dips strength standards calculated?

Standards are derived from aggregated training and competition data across large populations. Each bodyweight bracket has five thresholds - Beginner (top 80%), Novice (top 60%), Intermediate (top 40%), Advanced (top 20%), and Elite (top 5%) - representing where a lifter falls relative to the broader lifting community.

How do I increase my Dips?

Progressive overload is the core principle: consistently add small amounts of weight or reps over time. For strength, focus on sets of 3–6 at 80–90% of your 1RM. For hypertrophy, work in the 6–12 rep range. Ensure adequate sleep (7–9 hours), sufficient protein intake (1.6–2.2 g/kg bodyweight), and allow at least 48 hours between sessions targeting the same muscle group.

What is the difference between each strength level?

Beginner: just started training and making rapid linear progress. Novice: 1–2 years of consistent training. Intermediate: several years with structured periodisation. Advanced: competitive or near-competitive level requiring specialised programming. Elite: top-end competitive performance representing the top 5% of the lifting population.