LiftCodex is in alpha — data and features are still being refined.
LiftCodex

Hack Squat Strength Standards

For men · by bodyweight · in lb

Calculate your 1RM →
Average male Hack Squat
243 lb
at 181 lb bodyweight · Intermediate level
Bodyweight ratio
1.34×
bodyweight at intermediate level
Beginner
Top 80% of lifters
Novice
Top 60% of lifters
Intermediate
Top 40% of lifters
Advanced
Top 20% of lifters
Elite
Top 5% of lifters

Find Your Level

Enter your stats and we'll highlight your row and level in the table below.

Don't know your 1RM? Calculate it →
Bodyweight (lb) Beginner
Top 80%
Novice
Top 60%
Intermediate
Top 40%
Advanced
Top 20%
Elite
Top 5%
110 73 lb 121 lb 174 lb 238 lb 304 lb
121 73 lb 121 lb 174 lb 238 lb 304 lb
132 73 lb 121 lb 174 lb 238 lb 304 lb
148 86 lb 139 lb 198 lb 267 lb 340 lb
165 97 lb 159 lb 218 lb 284 lb 357 lb
181 106 lb 174 lb 243 lb 315 lb 392 lb
198 106 lb 174 lb 243 lb 315 lb 392 lb
220 115 lb 187 lb 260 lb 340 lb 425 lb
242 121 lb 198 lb 280 lb 364 lb 454 lb
264 121 lb 198 lb 280 lb 364 lb 454 lb
286 121 lb 198 lb 280 lb 364 lb 454 lb
308 121 lb 198 lb 280 lb 364 lb 454 lb

Hack Squat Strength Standards for Men

These hack squat strength standards cover male lifters across a range of bodyweights in LB. Each row shows five thresholds - Beginner, Novice, Intermediate, Advanced, and Elite - representing roughly the top 80%, 60%, 40%, 20%, and 5% of the lifting population at that bodyweight. Use the "Find My Level" tool above to enter your one rep max and see exactly where you stand.

Standards are based on aggregated data from large populations of raw, natural lifters. An intermediate hack squat is a realistic long-term goal for most people who train consistently - it typically requires 2–4 years of progressive training with structured programming. Advanced and Elite levels represent competitive performance and require deliberate, periodised training over many years.

Strength levels are always relative to bodyweight. A hack squat that is elite at 60 lb bodyweight is only intermediate at 100 lb - the absolute numbers scale with size. This is why every row in the table shows different thresholds rather than a single cutoff. If you are between bodyweight brackets, the standard for the nearest bracket is a reasonable guide.

Hack Squat Technique Cues

Setup
  • - Shoulder pads adjusted to fit, back flat against the pad
  • - Feet shoulder-width, toes angled slightly out
Cues
  • - Lower until thighs are parallel or below
  • - Push through the full foot on the ascent
  • - Keep lower back in contact with the pad
Common Mistakes
  • - Allowing the lower back to round off the pad at depth
  • - Feet too high on the platform (shifts load from quads to glutes/hamstrings)

Frequently Asked Questions

How much should a men hack squat?

For an average men weighing around 176 lb, an intermediate hack squat is approximately 243 lb. Standards vary significantly by bodyweight - use the "Find My Level" tool above with your own bodyweight to get a personalised figure.

What is a good Hack Squat for a beginner?

A beginner standard represents a lift achievable after a few months of consistent training - roughly the top 80% of the lifting population. For most exercises, this is around 50–60% of bodyweight for upper body movements and 75–100% for lower body lifts. Check the Beginner column in the table above for the specific number at your bodyweight.

How are Hack Squat strength standards calculated?

Standards are derived from aggregated training and competition data across large populations. Each bodyweight bracket has five thresholds - Beginner (top 80%), Novice (top 60%), Intermediate (top 40%), Advanced (top 20%), and Elite (top 5%) - representing where a lifter falls relative to the broader lifting community.

How do I increase my Hack Squat?

Progressive overload is the core principle: consistently add small amounts of weight or reps over time. For strength, focus on sets of 3–6 at 80–90% of your 1RM. For hypertrophy, work in the 6–12 rep range. Ensure adequate sleep (7–9 hours), sufficient protein intake (1.6–2.2 g/kg bodyweight), and allow at least 48 hours between sessions targeting the same muscle group.

What is the difference between each strength level?

Beginner: just started training and making rapid linear progress. Novice: 1–2 years of consistent training. Intermediate: several years with structured periodisation. Advanced: competitive or near-competitive level requiring specialised programming. Elite: top-end competitive performance representing the top 5% of the lifting population.