LiftCodex is in alpha — data and features are still being refined.
LiftCodex

T-Bar Row Strength Standards

For men · by bodyweight · in lb

Calculate your 1RM →
Average male T-Bar Row
194 lb
at 181 lb bodyweight · Intermediate level
Bodyweight ratio
1.07×
bodyweight at intermediate level
Beginner
Top 80% of lifters
Novice
Top 60% of lifters
Intermediate
Top 40% of lifters
Advanced
Top 20% of lifters
Elite
Top 5% of lifters

Find Your Level

Enter your stats and we'll highlight your row and level in the table below.

Don't know your 1RM? Calculate it →
Bodyweight (lb) Beginner
Top 80%
Novice
Top 60%
Intermediate
Top 40%
Advanced
Top 20%
Elite
Top 5%
110 57 lb 97 lb 139 lb 190 lb 243 lb
121 57 lb 97 lb 139 lb 190 lb 243 lb
132 57 lb 97 lb 139 lb 190 lb 243 lb
148 68 lb 110 lb 159 lb 214 lb 271 lb
165 77 lb 126 lb 174 lb 227 lb 284 lb
181 86 lb 139 lb 194 lb 251 lb 315 lb
198 86 lb 139 lb 194 lb 251 lb 315 lb
220 90 lb 150 lb 207 lb 271 lb 340 lb
242 97 lb 159 lb 223 lb 291 lb 364 lb
264 97 lb 159 lb 223 lb 291 lb 364 lb
286 97 lb 159 lb 223 lb 291 lb 364 lb
308 97 lb 159 lb 223 lb 291 lb 364 lb

T-Bar Row Strength Standards for Men

These t-bar row strength standards cover male lifters across a range of bodyweights in LB. Each row shows five thresholds - Beginner, Novice, Intermediate, Advanced, and Elite - representing roughly the top 80%, 60%, 40%, 20%, and 5% of the lifting population at that bodyweight. Use the "Find My Level" tool above to enter your one rep max and see exactly where you stand.

Standards are based on aggregated data from large populations of raw, natural lifters. An intermediate t-bar row is a realistic long-term goal for most people who train consistently - it typically requires 2–4 years of progressive training with structured programming. Advanced and Elite levels represent competitive performance and require deliberate, periodised training over many years.

Strength levels are always relative to bodyweight. A t-bar row that is elite at 60 lb bodyweight is only intermediate at 100 lb - the absolute numbers scale with size. This is why every row in the table shows different thresholds rather than a single cutoff. If you are between bodyweight brackets, the standard for the nearest bracket is a reasonable guide.

T-Bar Row Technique Cues

Setup
  • - Straddle the bar with a close grip (V-handle or similar)
  • - Hinge forward 45 degrees, flat back
  • - Bar loaded at the far end, pivot point fixed
Cues
  • - Pull the bar into your chest, keeping elbows close to your body
  • - Retract shoulder blades at the top
  • - Maintain your hip hinge position throughout the set
  • - Lower under control to full stretch at the bottom
Common Mistakes
  • - Standing too upright, which shifts focus from back to biceps
  • - Using momentum to swing the weight up
  • - Not achieving full shoulder blade retraction at the top

Frequently Asked Questions

How much should a men t-bar row?

For an average men weighing around 176 lb, an intermediate t-bar row is approximately 194 lb. Standards vary significantly by bodyweight - use the "Find My Level" tool above with your own bodyweight to get a personalised figure.

What is a good T-Bar Row for a beginner?

A beginner standard represents a lift achievable after a few months of consistent training - roughly the top 80% of the lifting population. For most exercises, this is around 50–60% of bodyweight for upper body movements and 75–100% for lower body lifts. Check the Beginner column in the table above for the specific number at your bodyweight.

How are T-Bar Row strength standards calculated?

Standards are derived from aggregated training and competition data across large populations. Each bodyweight bracket has five thresholds - Beginner (top 80%), Novice (top 60%), Intermediate (top 40%), Advanced (top 20%), and Elite (top 5%) - representing where a lifter falls relative to the broader lifting community.

How do I increase my T-Bar Row?

Progressive overload is the core principle: consistently add small amounts of weight or reps over time. For strength, focus on sets of 3–6 at 80–90% of your 1RM. For hypertrophy, work in the 6–12 rep range. Ensure adequate sleep (7–9 hours), sufficient protein intake (1.6–2.2 g/kg bodyweight), and allow at least 48 hours between sessions targeting the same muscle group.

What is the difference between each strength level?

Beginner: just started training and making rapid linear progress. Novice: 1–2 years of consistent training. Intermediate: several years with structured periodisation. Advanced: competitive or near-competitive level requiring specialised programming. Elite: top-end competitive performance representing the top 5% of the lifting population.